What do I do when OceanBase Store failed to access an OceanBase cluster through RPC?

This topic describes how to perform troubleshooting when OceanBase Store reports an RPC access failure.

Symptom

After a store is started, the timestamp remains unchanged, and the log/liboblog.log file prints an RPC access failure. You can run the following command to obtain the error information: grep "fail on rpc" liboblog.log. The error code is 4121, and the specific error information is as follows:

Possible causes

OceanBase Store needs to obtain clogs from the OBServer over the RPC port. If the port is inaccessible, OceanBase Store cannot obtain clogs, and therefore, the timestamp remains unchanged.

Troubleshooting procedure

1. Log on to the OBServer and query the svr_port and inner_port ports of the OBServer.

   

2. Use the telnet command in the OceanBase Migration Service (OMS) container to check whether the corresponding svr_port and inner_port ports corresponding to each svr_ip value are accessible,

   for example, telnet 123.123.XX.XX 26024. If these ports are inaccessible, enable the two ports.

   If the ports are accessible and the RPC failure persists, contact OMS service engineers for troubleshooting.