Create a Qdrant data source

Before you create a data migration or synchronization task, you must configure the data sources. This topic describes how to create a Qdrant data source in OceanBase Migration Service (OMS) Community Edition.

Prerequisites

You have obtained the IP address and port number of the related database.

Procedure

1. Log on to the console of OMS Community Edition.

2. In the left-side navigation pane, click Data Source Management.

3. On the Data Source Management page, click New Data Source in the upper-right corner.

4. In the New Data Source dialog box, select Qdrant for Data Source Type.

5. Configure the following parameters.

   Parameter	Description
   Data Source Identifier	We recommend that you set it to a combination of digits and letters. It must not contain any spaces and cannot exceed 32 characters in length. Notice The data source identifier must be globally unique in the system of OMS Community Edition.
   Region	Select the region where the data source resides from the drop-down list. The region is the value that you set for the cm_region parameter when you deploy OMS Community Edition. Notice This parameter is displayed only when multiple regions are available. Make sure that the mappings between the data source and the region are consistent. Otherwise, the migration and synchronization performance can be poor.
   Host IP Address	The IP address of the host where the database is located.
   http port (http_port)	The HTTP port of the Qdrant data source. Default value: 6333.
   rpc port (grpc_port)	The RPC port of the Qdrant data source. Default value: 6334.
   api-key (Optional)	You can set an API key in the upper-right corner of the Collections page.
   Remarks (Optional)	Additional information about the data source.

6. Click Test Connection to verify the network connection between OMS Community Edition and the data source.

7. After the test is passed, click OK.