Take over the Arbitration Service

This topic describes how to take over the Arbitration Service in OAT.

Prerequisites

Before you take over the Arbitration Service, make sure that the following conditions are met:

• You have added the Docker image of the Arbitration Service.
• You have installed OAT and logged in as a super administrator or an O&M engineer. For more information, see Install OAT.
• You have added a server to install the Arbitration Service. For more information, see Add a server.
• The server meets the requirements for installing the Arbitration Service.

Procedure

To take over the Arbitration Service, perform the following steps:

1. In the left-side navigation pane, choose Product Service > Components.

2. On the Component Management page, click Takeover component in the upper-right corner and choose Take Over Arbitration Service.

3. On the Take over NLB page, configure the parameters.

   The following table describes the parameters for taking over the Arbitration Service.

   Parameter	Explanation
   Arbitration Service Image	The Docker image of the Arbitration Service.
   Arbitration Service Component Name	The name of the component. The name must be unique.
   Server	The IP address of the server on which you want to take over the Arbitration Service. Note Make sure that a running container exists on each server.
   CPU	The number of CPU cores available to the Arbitration Service on the server.
   Memory	The size of memory available to the Arbitration Service on the server.

4. After you configure the parameters, click Sure..